When configuring a heat meter to work
with a Guru Hub III Core, upon the
commissioning of
the Core a meter needs to be approved to
work with our device.
Please also note that whilst we try to
ensure a broad range of compatibility, we
cannot guarantee results of meters we have
not tested, or meters that we have tested
but where there may be a firmware version
difference. If you do notice a firmware
version difference and compatibility
issues then please get in
touch.
In every case, please consult the
manufacturer's documentation on how to
connect the meter and in some cases
configure the meter to support mbus
fully.
Things to remember: If more than
one
meter exists on a Guru Hub III Core then
the mbus
addresses must not be the same on each
meter. You will need to have the mbus
addresses reconfigured for each of the
meters
Click on the name of the meter to see
associated data sheets where they are
available.
Approved Meters
All meters below must be at 2400 Baud
rate.
| Meter Name | Approved |
| Zenner Zelsius
C5 | Yes |
| Sontex
Superstatic 449 | Yes |
| Kamstrup
Multical 601 | Yes |
| Kamstrup
Multical 602 | Yes |
| Kamstrup
Multical 603 | Yes |
| Kamstrup
Multical 403 | Yes |
| Evinox Mod
RC15 | Yes |
| Zenner ERZ pulse | Yes |
| Itron CF Echo
II | Yes |
| Landis+Gyr
T230 Ultraheat | Yes |
| Engleman US2 | Yes |
| Danfoss
Sonometer 1000 | Yes |
| Maddelena
Evo | Yes |
| Kamstrup
Multical 402 | Yes |
| Ista T 230
Ultego III Smart | Yes |
| IZAR Port
Pulse Mini | Yes |
| Danfoss
Sonotometer 1100, Sharky 775,
Rossweiner
Ultrasonic | Yes |
| Inepro PRO 1 | Yes |
If you would like your meter added to this
list, please get in touch at support@gurusystems.com.